SparkFun PIR Motion Sensor (JST) Proximity Support Equipment Modeling Light The modeling light

Modeling Light The modeling light minimizes guesswork by approximating how the flash will illuminate your subject

Just connect your motors and your SPI-capable microcontroller and get steppin'

We’ve finally updated the connector

Enables you to shoot towards the light source

This isn’t your expensive

SparkFun PIR Motion Sensor (JST) Proximity Support Equipment Modeling Light The modeling lightThis is a simple to use motion sensor. Power it up and wait 1 2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the alarm pin will go low. This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3. 3V. Sensor uses 1. 6mA@3. 3V. The alarm pin is an open collector meaning you will need a pull up resistor on the