Ogee Stile Cutter Edge Profile 1/2" point length

1/2" point length

BISCUIT JOINING: This bit size is the proper dimensions needed for biscuit joining

SPECIFICS: Achieve the following rabbet depths with this set- flush trim

VERSATILITY: The extended nose on plunge roundover bits can also be used to trim your project

Perfect for adding a polished touch to any project

Ogee Stile Cutter Edge Profile 1/2" point lengthMaterials: Natural woods, composite woods Recommended RPM: 12,000 14,000 (max 16,000) This Stile Cutter makes full size joints on your router table. The interlocking design plus the raised panel groove are both cut in one pass. Ball bearing guides control the cutting depth and also allow use on rounded, arched, or special shaped doors. Ideal for stock from 5 8 to 7 8 thick. Also available as a set by ordering part number 6002. TOOL SPECS: Carbide