Red Coat Blockout Kits Thinning this product may reduce

Thinning this product may reduce the metallic sparkle

Enviro Clean will also reduce the incidence of "pinholes" when coating your screens with emulsion

strong contact to the point where the black ink on the film is almost embedded into the emulsion means that light has difficulty wrapping around the film

"Adhesive Remover" Apply Enviro Wipe to the adhesive and allow to dwell for 30 to 90 seconds

They aren't the thin handled squeegees you've seen out there

Red Coat Blockout Kits Thinning this product may reduceThis product is a medium viscosity, water soluble red blockout designed to fill the open areas of the screen not covered by the emulsion. I When the screen is dry and free of contaminants, pour RED COAT on the print side of the screen. Spread over the open areas of the screen until completely filled. II Touch up all defects, including heavy blobs which tend to dry the outside and pop off or smear during printing. Where very fine meshes are used, you