16 mm Internal grooving bar suitable to 2,3,4 mm tdc insert pack of 1 Size:4 MM RIGHT HAND T MAX 5 MM and even injuries to personnel

and even injuries to personnel

SNMU Carbide Insert with 8 Cutting Edge can be used in both 45 Degree And 90 Degree cutters

A light stroke on the punch will mark the workpiece below

the three-point inside micrometre may fulfil all your needs and be easy to handle

Right hand or left hand

16 mm Internal grooving bar suitable to 2,3,4 mm tdc insert pack of 1 Size:4 MM RIGHT HAND T MAX 5 MM and even injuries to personnelCHOOSE SIZE CAREFULLY MINIMUM ENTRY DIAMETER IS 22 MM Internal Grooving bar has different sizes. This is suitable for TDC, TDT, TDJ, and TDX. Suitable for Taegutec Tip Steps to choose the size. Entry Diameter of the component and bar entry dia should be less than the component entry dia The width you need inside. If you need a 2 mm groove width, you should choose a 2 mm grooving insert, and if you have a width of 3. 5 mm, you can do with either 2 mm